1
Figured out I was over-torquing anchor bolts for months
Was helping a buddy on a steel frame job in Denver last spring. He looked at my torque wrench setting and just laughed. Said I was cranking 1/2 inch bolts to 120 ft-lbs when spec says 75. I'd been doing it that way for like 3 years cause nobody ever checked. Felt like an idiot but now I double check the plans every time. Anyone else been humbled by a simple spec sheet read?
2 comments
Log in to join the discussion
Log In2 Comments
milesj7029d ago
That 120 to 75 is a brutal one man. Did you ever check if any of those bolts you overtightened actually had any damage or stretching when you went back with the right spec? I always wonder if stuff like that gets caught during inspection or if it just rides until something snaps.
2
lee7229d ago
Pretty sure they just rode until something snapped, @milesj70... never checked mine.
-1