6
Had a Honeywell panel lock up on me mid-programming last Thursday
I was setting up a Vista 20p in a new build in Tempe, had just finished running all the zones when the keypad went blank and wouldn't respond. I had to pull the battery and transformer leads for a full minute to get it to reboot. Anyone run into this with the newer Vista firmware?
3 comments
Log in to join the discussion
Log In3 Comments
alice_grant25d ago
Which firmware version was on the panel?
5
the_jenny19d ago
Wait, it locked up after you ran all the zones? I mean, that's the worst possible time for it to crash. You're basically done and then it just dies. I had one freeze on me once, but it was during a simple walk test. Having to pull both the battery and the transformer feels so extreme, like you're killing it to save it. That new firmware sounds like it's got some serious issues.
5